Home

  Imprint   Disclaimer

IBHsoftec GmbH

Turmstr. 77

64743 Beerfelden

Tel:     +49 6068 3001

Fax:    +49 6068 3074

info@ibhsoftec.de

Deutsch
IBH Link S7++
Item #20266

 

IBH Link S7++

If a S7 200® ,S7 300® or S7 400® has to be connected with a PC via Ethernet, the normal way is to take a CP / Communication processor. IBHsoftec has a more flexible solution:

IBH Link S7++.

If you want to connect your PC via Ethernet just take the IBH Link S7++ . It is possible to connect the IBH Link S7++ with a hub or switch or via a Crossover cable direct with your PC network card. The used protocol is standard TCP/IP, so you can control your system using VPN or a router. Of course you can also use an Internet connection. With the IBH Link S7++ online functions are possible via Profibus DP with up to 12 Mbit/s or via PPI/MPI®. The IBH Link S7++ will reduce your cost because there is no need for the CP’s from Siemens nor the software Simatic Net is required.
 

The IBH Link S7++ replaces the well known IBH Link S7 and IBH Link S7 CrossOver.

Additional features:

- New: Configuration via web browser

- New: Configuration via NetPro

- New: Windows 7 64 Bit support

- New: STEP®7 64 Bit support

- New: Time synchronisation

- New: PROFIBUS diagnostic

- New: Slave diagnostic

- New: Drive configuration

- New: Setting of the Slave Parameter via DPV1

- New: Data set routing

- New: Integration within the TIA portal

- New: DHCP
- New: Routing via RFC1006

- New: Fetch/Write via RFC1006
- New: PLC - PLC communication

- New: process data access with other PLC, Windows and

             Linux

- 16 PC-connections at the same time

- 32 MPI® / DP-connections at the same time

- Automatic Baudrate detection

- PG(PU)-connector

- RJ45-Plug with autodetect integrated

- Diagnostic LEDs

- Power supply from the MPI® / DP interface

- Connection also to passive nodes with

  power supply via integrated 24V connector

The driver for SIMATIC MicroWin® ,STEP®7, WinCC, ProTool and of course S7 for Windows® is supplied on CD with your IBH Link S7++. Also you can use the IBH OPC Server to connect your visualisation with the PLC via IBH Link S7++. The IBHNet driver enables you to gain direct variable access via standard programming languages like Visual Basic or Delphi. The configuration of the adapter is very easy and normally done in a few minutes. The IBH Link S7++ automatically detects, whether it’s connected to a 10 or 100Mbit/s network. The IBH Link S7++ takes it's power supply from the MPI®/DP interface, if available, otherwise via the integrated 24V plug.

Besides the programming capabilities also an application programming interface for HMI applications is included.
For Windows operating systems there are samples in the languages Visual Basic® , Visual C®, C++®, VB.net®, C#®, Delphi®, Java®, Excel® included. For Linux there are also samples included.

IBHNet Driverr Download

After installation the samples can be found at:

<Your drive > :\IBH softec GmbH\IBH_Net\Samples

 

HMI applications can also connect via ISO on TCP (RFC1006).

Typical application of the IBH Link S7++ :

 

Advanced operation ranges of the IBH Link S7++ :

PLC <-> PLC communication, projected with NetPro


 

 
  Top of page